Meet Pixie a pointed-toe flat mule, created on a vintage 1980 last (Ah memories of my wanton youth). Pixie is my first foray into working with soling weight leather. What an experience. The leather I have is thick with a veg tan finish. I think it will make for a sturdy sole, but boy is it hard to cut. After using my scalpel (too weak), a 45mm rotary cutter and leather scissors (both hard to control on curves and often crushed rather than cut) and my regular utility knife, I was defeated. I couldn't imagine how I would be able to do it. My hands hurt and were a bit numb. I wallowed in self-doubt and self-pity for about a minute and then did what any self-respecting maker would do - I went took a tour on the internet to see what I could dig up. Someone suggested an Olfa Heavy Duty Utility knife with heavy duty break off blades. Thanks to Amazon Prime, I got my new knife/blades, a 60mm rotary cutter and blades for the 60mm and 45mm the next day. I also got an electric rotary cutter, but I haven't tried it yet. The rough edge gave me an opportunity to learn about edge finishing. The insole on this baby is another piece of lighter weight leather. Between the 2 pieces and the heel, I was able to learn to bevel edges, sand and burnish edges. I got to experiment with my Dremel tool which proved to be a life saver. This shoe is 4 component pieces and again I was working with all cement construction. I knew I wanted a nice finished edge to the upper so I got to incorporate topline tape and I repeated that folded edge that mimics a sewn edge with the construction. Here you can see the folded top edge and skived edges of the upper ready to be glued over the last to the French Beveled insole. ( Another tool in my tool kit!) Several wrappings and edge finishings later Pixie debuted. Even with a few warts (I need to get the upper flatter to connect more seamlessly with the sole), I love her shape, style and spunk. She's mine to test as we transition into Fall. I definitely need some more work on cutting veg tan sole material and finishing these edges. The only way to get better is to do it, so I carry on.